audi Workshop Repair Guides

Audi Workshop Service and Repair Manuals

ABOUT US
Removing and installing bracket for ancillaries > < Removing and installing poly V-belts

A4 Mk1

Removing and installing vibration damper
Removing and installing vibration damper
   
Removing
–  Move lock carrier to service position → Rep. Gr.50.
–  Remove poly V-belt → Chapter.
–  Counterhold by applying ring spanner to bolt for toothed belt sprocket and unbolt vibration damper.
  A13-0356
Installing
–  Installation is carried out in the reverse order; note the following:
  Note
t  Renew bolts for vibration damper.
t  The vibration damper can only be installed in one position. The hole -arrow- in the vibration damper must be located over the projection on the toothed belt sprocket.
–  Install poly V-belt → Chapter.
  A13-0134
–  Install lock carrier with attachments → Rep. Gr.50.
–  Allow stop for torque reaction support to rest on rubber buffer for torque reaction support under its own weight and tighten nuts -arrows-.
Tightening torques
  A10-0767
ComponentNm
Vibration damper with pulley to crankshaft10 + 90° 1)
Stop for torque reaction support to sump28
l  1) Renew bolts.
l  2) 90° = one quarter turn.

   

Removing and installing bracket for ancillaries > < Removing and installing poly V-belts