–
| To remove pipe/hose assembly, use a screwdriver to lever off clip -A- as far as the stop. Only then can the pipe/hose assembly be pulled out. |
Installation is carried out in reverse sequence; note the following: |
t
| Do not allow brake fluid to come into contact with the gearbox. If necessary, clean the gearbox housing. |
t
| For easier installation engage 6th gear before fitting slave cylinder. |
t
| When installing, press in slave cylinder so that securing bolt can be fitted easily. |
t
| Renew securing bolt for slave cylinder. |
–
| Using copper grease (commercially available), lightly lubricate surface where plunger and clutch release lever make contact. |
|
|
|