A4 Mk2
| Exploded view - selector lever cable and locking cable |
Note| t | Do not bend or kink the selector lever cable. |
| t | Before installing, lightly lubricate cable eye and ball socket with polycarbamide grease -G 052 142 A2-. |
| 1 - | Selector lever cable |
| q | Do not bend or kink, lightly grease cable eye and ball socket before installing. |
| q | Removing and installing → Chapter |
| q | Adjusting → Chapter |
| q | Renew selector lever cable if the rubber sleeves are damaged |
| q | Make sure that rubber sleeve (at gearbox end) is not twisted when installing |
| 2 - | Lock nuts |
| q | 13 Nm |
| 3 - | Retaining clip |
| 4 - | Ignition/starter switch |
| q | With ignition key removal lock |
| 5 - | Locking cable |
| q | For ignition key removal lock |
| q | Must not be kinked |
| q | Removing and installing → Chapter |
| q | Adjusting → Chapter |
| 6 - | Bolt |
| q | 9 Nm |
| 7 - | Clamping bolt |
| q | For selector lever cable |
| q | Loosen 1 turn for adjusting, do NOT remove completely |
| q | 13 Nm |
| 8 - | O-ring |
| q | Renew |
| 9 - | Retaining clip for selector lever cable |
| 10 - | Bolt |
| q | Secures support bracket to bracket for selector lever cable |
| q | 20 Nm |
| 11 - | Support bracket for selector lever cable |
| q | Different brackets according to version |
| 12 - | Bolt |
| q | Secures bracket for selector lever cable to gearbox |
| q | 20 Nm |
| q | 3x |
| 13 - | Bracket for selector lever cable |
| q | Different brackets according to version |
