A4 Mk3
| Removing and installing sliding/tilting sunroof frame |
| 1 - | Bolt |
| q | 8 Nm |
| 2 - | Bolt |
| q | 3 Nm |
| 3 - | Sliding sunroof adjustment control unit -J245- |
| q | Performing adaption → Chapter |
| 4 - | Sliding/tilting sunroof frame |
| q | Removing |
| – | Headliner removed. |
| – | Unplug electrical connectors. |
| – | Disconnect water hoses (front and rear). |
Note| t | Only unscrew central bolts (at sides) from frame as a final step. |
| t | Two mechanics must hold the frame in position so that a third can remove the bolts and the frame can be lifted out. |
| – | Unscrew bolts on both sides; do not unscrew central bolts. |
| – | Have other mechanics hold frame; only then can central bolts be unscrewed and frame be lifted out of vehicle towards rear. |
| q | Installing |
| – | Loosely secure frame with bolts. |
| – | Locate frame at locating holes with Ø 8 mm drill (front and rear) → Anchor. |
| – | Tighten bolts along width of frame to torque (first at front, then at rear). |
| – | Tighten bolts along length of frame alternately to torque (from rear to front). |
| – | Connect water drain hoses (front and rear) to frame. |
| 5 - | Roof |
| 6 - | Sunroof roller blind control unit -J394- |
| q | Performing adaption → Chapter |
| 7 - | Sun blind |
| q | Removing → Chapter |
|
|
|
|
