audi Workshop Repair Guides

Audi Workshop Service and Repair Manuals

ABOUT US
Removing and installing reversing cameraR189 (Avant) > < Removing and installing reversing camera system control unitJ772

A4 Mk3

Removing and installing reversing cameraR189 (saloon)
Removing and installing reversing camera -R189- (saloon)
Reversing camera -R189- is installed in handle in rear lid.
–  Switch off all electrical equipment.
–  Remove ignition key.
Removing
Reversing camera -R189- is equipped with a trailing cable. Connectors to vehicle wiring harness are located in rear lid.
–  Remove rear lid trim → General body repairs, interior; Rep. gr.70.
   
–  Unscrew nuts -2-.
Reversing camera -R189- is permanently fitted in handle -3-.
–  Pull handle -3- together with reversing camera -R189- out of rear lid.
  A91-10644
–  Release and unplug connectors -1- and -2- in rear lid.
–  Remove handle from rear lid.
Installing
–  Install in reverse sequence of removal.
–  Close rear lid.
–  Perform calibration → Chapter.
Tightening torques → Chapter
  A91-10980

Removing and installing reversing cameraR189 (Avant) > < Removing and installing reversing camera system control unitJ772