Q5 Quattro V6-3.2L (CALB) (2009)
/Page-1847004.png)
Replacement/Rear Suspension/Shock Absorber
32
Protective sleeve
33
Buffer stop
34
Bolt
‹› 50 Nm plus an additional 45° turn
‹› Always replace after removal
35
Upper shock absorber mount
‹› Installed position => [ Upper shock absorber mount installation position ] See: Suspension Strut / Shock Absorber/Service and
Repair/Removal and Replacement/Rear Suspension/Shock Absorber, Servicing
36
Nut
‹› 35 Nm
‹› Always replace after removal
37
Protective cap
Avoid contaminating with dirt and damaging the seal when setting down/storing.
‹› The wheel bearing - 1 - must always face up.
‹› Always set the wheel bearing down on the wheel hub - 2 -.
The same procedure also applies to the wheel bearing without a wheel hub.
