3 Series E46 316i (N42) SAL
Installation:
Correctly install wiring harness with grommet in cover (water
tightness).
Hook cover (3) into hinges of underside of electronics box (1).
Make sure upper stop (2) is correctly installed above hinges on
underside of electronics box.
Assignment of electronics box (with automatic transmission):
1 = Control unit, Digital Motor Electronics (DME)
2 = Control unit for automatic transmission
Disconnect plug connections (1).
Remove control unit (2).
Installation:
Replacement:
Observe equipment no. and coding.
Note:
Interrogate fault memory of DME control module.
Check stored fault messages.
Rectify faults.
Then clear fault memory.
RA Replacing control module (DME)
BMW AG - TIS
20.01.2013 19:14
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -
