3 Series E90 320d (M47T2) SAL
Lever out retainer (1).
Disengage shift rod (2).
Installation:
Grease shift rod.
Grease,
Refer to BMW Service Operating Fluids.
Make sure shims (3) are in correct position.
Release and remove bearing pins (1) in direction of arrow.
Lift out shift arm (1).
Installation:
Grease bearing pins (1).
Grease,
Refer to BMW Service Operating Fluids.
Note:
Pressure line of clutch slave cylinder remains connected.
Important!
Slowly relieve tension on clutch slave cylinder otherwise air is
drawn in through sealing sleeve.
Release nuts and remove clutch slave cylinder.
Tightening torque 21 52 5AZ
.
RA Removing and installing transmission (GS6-37DZ) M47T2
BMW AG - TIS
23.01.2013 07:59
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 3 -
