5 Series E39 M5 (S62) SAL
Caution!
After unclipping pull rods on throttle side, return throttles
slowly to stops.
Note:
If the pull rod length has to be checked or adjusted, also press
the pull rod off the ball head on the throttle side. Open
throttles to do so.
Initial adjustment of pull rod length (center distance of ball
sockets):
1.
Non-adjustable pull rod (cylinder bank 1-4): 131.7
±
0.4
mm
2.
Adjustable pull rod (cylinder bank 5-8): 133
±
0.8 mm
Note:
Due to tolerances, the adjustable pull rod is installed on some
vehicles for both cylinder bank 1-4 and cylinder bank 5-8.
Further procedure for such vehicles,
refer to 13 54 ...
Clip in non-adjustable pull rod (1) on throttle and servomotor
sides.
Clip in adjustable pull rod (2) on throttle side and rest against ball
head on servomotor side. If necessary, correct length of
adjustable pull rod by turning hexagon head so that ball socket is
centrally aligned to ball head.
Then clip in adjustable pull rod (2) on ball head on servomotor
side.
RA Removing and installing/replacing throttle actuator (S62)
BMW AG - TIS
21.02.2013 16:07
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 4 -
