Century V6-3.1L VIN J (2005)
17. Unlock the booster from the cowl.
18. Use a flat-bladed tool to depress the brake booster locking tab (1) out of the cowl mounting flange, while turning the booster counterclockwise
with a ratchet on the J 22805-B (2).
19. Remove the vacuum brake booster.
20. Remove the J 22805-B (2) from the booster.
Installation Procedure
Notice: Internal components of this booster are not serviceable. The housing must not be unstaked and separated. Separating the housing will cause
permanent deformation, preventing the booster from holding proper volume.
Notice: Inspect the locking flanges on booster and mounting plate. Replace the booster and mounting plate if the locking flanges are bent or
damaged.
1. Important: Carefully push the pushrod eye through the hole so that you do not damage or dislodge the insulator boot.
Install the vacuum brake booster. Position the vacuum brake booster on the cowl counterclockwise from the final installation position so that the
locking flanges on the vacuum brake booster and on the cowl mounting flange engage.
