CTS V6-2.8L (2006)
Steering Gear: Service and Repair
Power Steering Gear Solenoid/Actuator Replacement
Power Steering Gear Solenoid/Actuator Replacement
Removal Procedure
1. Raise and support the vehicle. Refer to Vehicle Lifting.
2. Remove the front tire and wheel.
3. Remove the front air deflector for access. Refer to Air Deflector Replacement - Front in Body and Frame.
4. Clean any dirt or debris from the power steering gear solenoid wiring harness to brake controller connector.
5. Remove the power steering gear solenoid/actuator wiring harness from the 2 plastic wiring harness retainers.
6. Disconnect the power steering gear solenoid/actuator wiring harness.
7. Clean any dirt or debris from the power steering gear solenoid/actuator.
Important: Do not get dirt on the lower portion or the solenoid below the hex or inside the solenoid port of the steering gear.