CTS V6-2.8L (2006)
8. Using a pair of adjustable pliers or equivalent, remove the power steering gear solenoid/actuator from the steering gear in a counter clockwise
rotation.
9. Remove the power steering gear solenoid/actuator from the vehicle.
Installation Procedure
1. Insure the new power steering gear solenoid/actuator has 2 O-rings visible beneath the hex.
2. Taking care not to contaminate the steering gear, install the power steering gear solenoid/actuator.
Important: Do not get dirt on the lower portion or the solenoid below the hex or inside the solenoid port of the steering gear.
3. Tighten the solenoid to 18 Nm (14 ft. lbs.).
Notice: Using the open-end crowfoot that comes in the kit, install the power steering gear solenoid/actuator in the steering gear.