DeVille DHS V8-4.6L VIN Y (2000)
1. Install the new manifold gasket over the cylinder head studs.
Notice: Refer to Fastener Notice in Service Precautions.
2. Install the manifold (1) and the nuts.
Tighten the nuts to 25 Nm (18 ft. lbs.).
3. Install the right side cylinder head to the transaxle brace.
Tighten the bolt and nut to 47 Nm (35 ft. lbs.).
4. Raise the engine cradle into position.
5. Install the four rearward cradle-to-body bolts.
Tighten the four bolts to 191 Nm (141 ft. lbs.).
6. Remove the screw jack.
