SRX AWD V6-3.6L (2008)
30.
Loosen the retaining clips on the sides of the electrical center and remove.
31.
Remove the electrical connector as seen in the illustration above.
32.
Splice into the ABS ignition feed circuit 2039 (J 134 cavity 39).
33.
Strip back 1 to 2 inches of insulation on the feed wire for the vacuum pump.
34.
Center strip the insulation on the existing circuit and pull back the insulation in both directions.
35.
Wrap the new wire around the existing circuit and solder the splice.
36.
Pull the new wire along the side of the existing circuit and wrap it with 3M Electrical Moisture Sealant Tape.
37.
Install the electrical connectors to the underhood electrical center.
38.
Install the underhood bussed electrical center and tighten the fastener.
Tighten
Tighten the fastener to 7 N.m (62 lb in).
39.
Install the cover.
40.
Remove the 10 amp fuse for the ABS ignition feed circuit and replace it with a 15 amp fuse.
41.
Install the cover.
Purchase the following material locally.
^
3M Electrical Moisture Sealant Tape P/N 06149
^
(15/32") or (1/2") ID reinforced EPDM rubber vacuum hose
Inoperative Vacuum Pump
