SRX AWD V6-3.6L (2008)
tighten the nut and bolt to 9 N.m (80 lb in).
14.
Install the 12 mm nut onto the strut module mounting stud and tighten.
Tighten
Tighten the nut to 50 N.m (37 lb ft).
15.
Tighten the 6 mm nut on the stud.
Tighten
Tighten the nut to 9 N.m (80 lb in).
16.
Cut a piece of 12 mm (15/32") ID reinforced EPDM rubber vacuum hose 1250 mm (49-1/4") long. Install a hose clamp on each end of the hose.
17.
Install the hose to the vacuum pump outlet port (THE PORT FACING DOWN). Move the hose clamp into position to secure the hose to the
pump.
18.
Route the hose behind the engine and connect it to the vacuum port on the engine and install the hose clamp.
Important:
Be careful not to kink the hose.
19.
Cut a piece of 12 mm (15/32") ID reinforced EPDM rubber vacuum hose 990 mm (39") long and install a hose clamp on each end.
20.
Install the hose to the inlet port of the vacuum pump that faces the engine. Route the hose behind the engine and connect it to the brake booster
valve.
21.
Secure each end of the hose with the clamps.
22.
Install a tie strap around the hoses and the battery ground cable.
23.
Install a tie strap around the hoses and the wiring harness in the back of the engine as seen in the illustration.
24.
Install the engine cover.
25.
Install the cross vehicle brace.
Tighten
tighten the brace bolts to 25 N.m (18 lb ft).
26.
Route the vacuum pump harness around the strut tower and secure the ground strap to the ground on the strut tower.
27.
Remove the cover from the underhood bussed electrical center (UHBEC).
28.
Remove the positive battery cable from the electrical center.
29.
Loosen the retaining bolts in the electrical center.
