STS RWD V8-4.6L (2007)
Installation Procedure
1. Align the timing marks (1) of the camshaft intermediate and crankshaft sprockets. The marks should be aligned vertically in the installed position.
2. Install the primary camshaft drive chain on the drive sprockets.
3. Use the J 39946 to rotate the crankshaft until the crankshaft keyway is approximately at the 1 o'clock position.
4. Install the following as an assembly:
*
The primary camshaft drive chain (3)
*
The crankshaft sprocket
*
The camshaft intermediate sprocket
Notice: Refer to Fastener Notice.
