STS RWD V8-4.6L (2007)
Camshaft Gear/Sprocket: Service and Repair
Camshaft Intermediate Drive Shaft Replacement
Removal Procedure
1. Remove the camshaft intermediate drive shaft sprocket.
Important: The camshaft intermediate drive shaft should not be removed unless wear is evident.
2. Remove the camshaft intermediate drive shaft retaining bolts.
3. Remove the camshaft intermediate drive shaft from the engine.
4. Clean and inspect the camshaft intermediate driveshaft.
Installation Procedure
1. Position the camshaft intermediate drive shaft to the engine, aligning the bolt holes.
Notice: Refer to Fastener Notice.
2. Install the camshaft intermediate drive shaft retaining bolts.
Tighten the camshaft intermediate drive shaft retaining bolts to 15 N.m (11 lb ft).
3. Install the camshaft intermediate drive shaft sprocket.