STS RWD V8-4.6L (2007)
12. Clean and inspect the camshaft timing drive components.
Installation Procedure
1. Position the left secondary camshaft drive chain shoe in through the left front cylinder head as shown.
Notice: Refer to Fastener Notice.
2. Install the left secondary camshaft drive chain shoe bolt.
Tighten the secondary camshaft drive chain shoe bolt to 25 N.m (18 lb ft).
3. Install the left intake actuator to the secondary chain, ensuring that the actuator timing mark is aligned with the chain link that was marked during
disassembly.
4. Loosely install the oil control valve to secure the intake actuator to the camshaft.
Notice: Refer to Torque Reaction Against Timing Drive Chain Notice.
5. Use an open-end wrench on the hex cast into the camshaft in order to prevent the camshaft from rotating when tightening the oil control valve.
Tighten the oil control valve to 120 N.m (89 lb ft).
