STS RWD V8-4.6L (2007)
Camshaft Position Actuator Oil Control Valve Replacement - Bank 2 (Left Side) Intake
Tools Required
*
J 39946 Crankshaft Socket
*
EN 46327 Timing Chain Retention Tool
*
EN 46328 Camshaft Holding Tool
Removal Procedure
1. Remove the left actuator housing. DO NOT remove the camshaft position (CMP) actuator solenoids from the housing.
2. Remove the crankshaft balancer.
Important: The secondary timing chain has black links that are used for alignment when the primary and secondary timing gear and
chain assemblies are being installed together. IT IS NOT NECESSARY for the black chain links to be aligned with the camshaft actuator
timing marks when the secondary chain and gear components are being serviced separately.
3. Using the J 39946, rotate the crankshaft until both bank 2 (left) CMP actuator timing marks are perpendicular (90 degrees) to the cylinder head
deck surface and near the top of their rotation.
Caution: Refer to Camshaft Holding Tool Caution.
4. Install the EN 46328 (1) to the camshafts (2).
