Cruze L4-1.4L Turbo (2011)
7. Remove the valve keys, valve spring retainers and the valve springs of the intake valves of cylinder 1, using the following procedure:
Caution: The demounting piece part of EN-6086 Basic Kit, Spring and Wedge Replacer must be applied parallel to the valve retainers in
order to prevent damage to the tools or the valve train components. If demounting piece is not applied parallel it could cause damage to the
valve stem keys or the valve retainers.
1. Apply tension to the valve springs, using the EN-6086-7 - lever (1) and the EN-6086-11 - demounting piece (2) until the valve keys are
discharged from spring load and remove the valve keys.
2. Release tension from the valve springs and remove the valve spring retainers and the valve springs.
8. Remove the intake valve stem oil seals (2) of cylinder 1, using the EN-840 - pliers (1).
Intake Valve Stem Oil Seal Installation Cylinder 1
