Equinox AWD V6-3.4L (2008)
Air Door Actuator / Motor: Service and Repair
Mode Control Cam Replacement
Mode Control Cam Replacement
Removal Procedure
1. Remove the left side insulator/closeout panel.
2. Remove the communication interface module, if equipped.
3. Disconnect the electrical connector from the mode actuator.
4. Remove the mode actuator screws from the evaporator case assembly.
5. Remove the mode actuator from the evaporator case assembly.
6. Remove the screws retaining the mode cam bracket (1) to the evaporator case assembly.
7. Remove the mode cam bracket (1) from the evaporator case assembly.
8. Remove the mode cam (2) and the mode cam levers (3) from the evaporator case assembly.