Malibu L4-2.4L (2010)
Installation Procedure
Caution: This is a self-retaining fastener joint that does not require thread locking compounds. Do not attempt to clean the threads with a
standard tap. If a standard tap is used, damage to the joint threads will occur.
1. Install the brake caliper mounting bracket to the steering knuckle.
Caution: Refer to Fastener Caution (See: Service Precautions/Vehicle Damage Warnings/Fastener Caution).
2. Install the brake caliper mounting bracket bolts (1) and tighten to 130 Nm (96 lb ft).
3. Apply a very thin coating of high temperature silicone brake lubricant to the pad hardware mating surfaces (1) of the caliper bracket only.
4. Clean the brake pad mating surfaces of the brake pad retainers (2).
5. Install the brake pad retainers (2) to the brake caliper bracket.