Malibu L4-2.4L (2010)
Important: Ensure that the ignition key is in the RUN position. Do not attempt to insert the park lock cable with the key in any other
position.
6. Install the cable (1) into the inhibitor housing.
7. Turn key to LOCK position.
8. Attach the park lock cable to the shift control base. Ensure the park lock cable retainer (2) is fully secured to the shift control base.
9. Install the park lock cable on the park lock lever by sliding the cable end (1) over the park lock lever pin.
10. Inspect the functional operation of the park/lock cable. Refer to Park Lock Cable Adjustment (See: Adjustments/4T45-E - Automatic
Transmission).
11. Install the knee bolster. Refer to Driver Knee Bolster Panel Replacement (See: Restraint Systems/Knee Diverter/Service and Repair).
12. Install the console. Refer to Front Floor Console Replacement (See: Body and Frame/Interior Moulding / Trim/Console/Service and Repair/Front
Floor Console Replacement).
13. Enable the SIR system. Refer to SIR Disabling and Enabling (See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument Panel/Air
Bag(s) Arming and Disarming/Service and Repair).
