Pacifica V6-3.8L (2008)
5. Remove two caliper guide pin bolts (2).
6. Remove caliper assembly from brake adapter by first rotating bottom of caliper away from rotor, then lifting caliper (with shoes) away from upper
adapter abutment.
7. Remove outboard brake pad by pushing pad away from caliper fingers, dislocating locating pins (1) built into pad backing plate from holes (3) in
caliper fingers, then sliding brake pad down and off of brake caliper.
8. Pull inboard brake shoe away from caliper piston, dislocating retaining clip from cavity in piston. Remove inboard shoe.
Front
INSTALLATION
CAUTION: If adhesive is missing from noise suppression gasket on rear of either inner and outer brake pads or if gasket is damaged, replace
brake pads. See: Disc Brake System/Brake Pad/Service and Repair/Brake Pads - Removal
CAUTION: Use care when installing caliper onto disc brake adapter to avoid damaging boots on caliper guide pins.
