Pacifica V6-3.8L (2008)
Parking Brake Lever: Service and Repair
Installation
INSTALLATION
1. Slide leading end of front parking brake cable into hole in flange of lever. Slide cable retainer on end of cable housing into hole until retainer
fingers click into place.
2. Pull button on end of cable strand out of housing and route around lever cam up to take-up reel.
3. Install front cable button (1) into lever take-up reel (2) as shown.
4. Slide any extra cable back into housing.
5. Position lever against left lower cowl (1) and install two mounting bolts (3) and one nut (2). Tighten all three fasteners to 28 Nm (21 ft. lbs.).
6. Install body control module mounting bracket. Install three mounting nuts and two wiring routing clips. Tighten all three fasteners to 14 Nm (125
in. lbs.).
7. Install body control module. See: Body and Frame/Body Control Systems/Body Control Module/Service and Repair/Body Control Module -
Installation
