PT Cruiser L4-2.4L Turbo (2009)
Suspension Strut / Shock Absorber: Overhaul
Front Suspension Strut Assembly - Disassembly
DISASSEMBLY
NOTE: The Strut assembly must be removed from the vehicle for it to be disassembled and assembled. See: Removal and Replacement/Front
Strut / Shock/Removal
For the disassembly and assembly of the strut assembly, use strut spring compressor, team PSE tool 223-7400, or the equivalent, to compress the coil
spring. Follow the manufacturer's instructions closely.
WARNING: Do not remove the strut shaft nut before the coil spring is compressed. The coil spring is held under pressure and must be
compressed, removing spring tension from the upper mount and pivot bearing, before the shaft nut is removed.
1. If both struts are being serviced at the same time, mark both the coil spring and strut assembly according to which side of the vehicle the strut is
being removed from.
2. Position the strut assembly (3) in the strut coil spring compressor (5) following the manufacturers instructions. Set the lower hooks (1). Position
the strut clevis bracket (4) straight outward, away from the compressor. Place a clamp (2) on the lower end of the coil spring, so the strut is held in
place once the strut shaft nut is removed.
