Sebring V6-2.5L VIN N (1997)
16. Because the seal rings expand at the time of installation, tighten after installation by using the special tool to compress the rings, or press down
by hand.
17. Using the special tool, press the oil seal into the valve housing.
CAUTION: In order to eliminate a seal malfunction at the valve housing alignment surface, the upper surface of the oil seal should project
outward approximately 1 mm (0.04 inch) from the housing edge surface.
18. Apply 3M ATD Part No. 8663 or equivalent to the threaded part of the end plug.
19. Secure the threaded portion of the end plug at two places by using a punch.
20. Position rack at its center. Tighten rack support cover to 15 Nm (11 ft. lbs.).
21. In neutral position, rotate pinion shaft clockwise one turn/4 - 6 seconds with special tool. Return rack support cover 30° - 60° and adjust torque
to the standard value.
22. Using the special tools, rotate the pinion gear at the rate of one rotation in approximately 4 to 6 seconds to check the total pinion torque. The
