Sebring Sedan L4-2.4L VIN J (2004)
11. Remove the hold-down clip from the front park brake shoe (Fig. 95). Then remove front park brake shoe.
INSTALLATION
1. Install front brake shoe and hold down clip (Fig. 95).
2. Install the rear park brake shoe and the park brake shoe upper return spring (Fig. 94).
3. Pull rear brake shoe over anchor block until properly located on adapter.
4. Install the park brake lower return spring (Fig. 93).
5. Install the adjuster between the park brake shoes. Adjuster must be installed with the star wheel toward the rear of the vehicle (Fig. 92).
6. Install hold down clip on rear park brake shoe (Fig. 91).
7. Adjust park brake shoes to an outside diameter of 171 mm (6.75 inch).
8. Install hub/bearing on knuckle.
9. Install A NEW hub/bearing retaining nut. Tighten the hub/ bearing retaining nut to a torque of 250 Nm (185 ft. lbs.).
10. Install dust cap on hub/bearing.
11. Install rotor.
12. Install rear disc brake caliper on adapter.
13. Install wheel and tire.
14. Tighten wheel stud nuts to 135 Nm (100 ft. lbs.).
