Lanos S Sedan L4-1.6L DOHC D-TEC MFI (2001)
2. Insert the plastic sleeve into the brake backing plate and press in the retaining ring. Make sure the parking brake cable is routed correctly.
3. For the ABS braking system (shown), install the brake drums and the detent screw. For the non-ABS braking system, remove the brake drums by
unfastening the split pin and the castle nut.
-
Tighten the rear brake drum detent screw (ABS) to 4 Nm (35 inch lbs.).
-
Tighten the rear brake drum castle nut (non-ABS) to 25 Nm (18 ft. lbs.) minus 180° plus 2 Nm (18 inch lbs.).
4. Install the rear wheels.
5. Install the parking brake cable to the fuel tank bracket.
-
Tighten the parking brake cable-to-fuel tank bracket nut to 12 Nm (106 inch lbs.).
6. Install the parking brake cable on the wire hanger (passenger side only).
7. Insert the brake cable into the open-ended holding bracket near the wire hanger.
