Lanos S Sedan L4-1.6L DOHC D-TEC MFI (2001)
2. Install the pulley on the pump. Install the steering pump pulley bolts.
3. Install the pump drive belt.
4. Tighten the steering pump pulley bolts to fasten the pulley to the pump.
Tighten the steering pump pulley bolts to 25 Nm (18 ft. lbs.).
5. Adjust the belt tension.
6. Install the air cleaner housing with the housing bolts and the clamp.
Tighten the air cleaner housing bolts to 12 Nm (106 inch lbs.).
7. If the pump was removed from the engine, bleed the power steering system.
Notice: When adding fluid or making a complete fluid change, always use DEXRON III power steering fluid. Failure to use the proper fluid will
cause hose and seal damage and fluid leaks.
8. Inspect for leaks. If leaks are found, correct the cause of the leak and bleed the system.
