Charger V8-5.7L (2008)
1. Using a trim stick or another suitable wide flat-bladed tool, carefully pry the upper end of the A-pillar trim (1) rearward from the inside of the
A-pillar (3) far enough to disengage the two spring clip retainers that secure the trim to the slots in the pillar.
2. Disengage the base of the A-pillar trim from the end of the instrument panel top cover.
3. Remove the A-pillar trim from the vehicle.
A-Pillar Trim Panel-Installation
INSTALLATION
1. Check to be certain that the energy absorbing cartridge (1) is properly installed and in good condition on the inside of the A-pillar (2). Replace the
cartridge if any damage is evident. Tighten the screws (3) to 3 Nm (25 in. lbs.).
2. Check to be certain that the grommet (2) for the front tether of the side curtain airbag is properly installed and in good condition. Replace the
grommet if any damage is evident. See: Restraint Systems/Air Bag Systems/Air Bag/Service and Repair/Side Curtain Airbag - Removal.
