Intrepid V6-2.7L VIN R (2003)
5. Remove the outer tie rod from the steering arm using Puller, Special Tool C-3894-A.
6. Remove outer tie rod from adjustment sleeve.
INSTALLATION - OUTER TIE ROD
1. Install the outer tie rod into the adjustment sleeve. Do not tighten the adjustment pinch bolt at this time.
2. Install the outer tie rod into the steering arm on front strut. Install tie rod to steering arm attaching nut. Tighten the attaching nut a torque of 37 Nm
(27 ft. lbs.).
3. Install the tire and wheel assembly.
4. Install and tighten the wheel mounting nuts in proper sequence until all nuts are torqued to half specification. Then repeat the tightening sequence
to the full specified torque of 135 Nm (100 ft. lbs.).
5. Lower vehicle.
