Magnum SRT-8 V8-6.1L VIN 3 (2006)
INSTALLATION
NOTE: Perform Step 1 through Step 10 on each side of vehicle to complete pad set installation before proceeding with Step 11.
1. Make sure all caliper pistons are fully seated (bottomed) in bores.
2. Slide NEW inboard (2) and outboard brake pads into opening (1) in disc brake caliper. If installing rear brake pads, make sure beveled end of each
pad lining is directed against the direction the rotor is rotating in when vehicle is moving forward, in other words, the rear pads need to have
beveled end facing upward.
3. From inboard side, slide upper brake pad support pin (2) through caliper (3) and upper holes in both brake pads (1). Ensure that small end of
support pin is in hole (4) in outboard half of caliper.
