Magnum SRT-8 V8-6.1L VIN 3 (2006)
Brake Master Cylinder: Service and Repair
Master Cylinder Fluid Reservoir
RESERVOIR - MASTER CYLINDER FLUID
REMOVAL
1. Remove access panel (1) in cowl area to expose master cylinder (2).
2. Thoroughly clean all surfaces of brake fluid reservoir and master cylinder. Use only Mopar® Brake Parts Cleaner or equivalent.
3. Remove brake fluid reservoir cap (1). Using a clean syringe or equivalent type tool, empty as much brake fluid as possible from the reservoir.
CAUTION: When removing fluid reservoir from the master cylinder, do not pry off using any type of tool. This can damage the fluid reservoir or
master cylinder housing.
4. Remove screw (3) fastening fluid reservoir to master cylinder housing.
5. Rock the brake fluid reservoir side-to-side while pulling up to remove it from seal grommets in master cylinder housing.