Magnum SRT-8 V8-6.1L VIN 3 (2006)
1. Install NEW brake fluid reservoir sealing grommets (2) in master cylinder housing (1).
2. Lubricate reservoir mounting area with fresh clean brake fluid. Place reservoir in position over sealing grommets. Seat reservoir into sealing
grommets using a rocking motion while firmly pressing down on fluid reservoir. Once installed, make sure fluid reservoir is touching the top of
both sealing grommets (2) or reservoir is not properly installed.
3. Install fluid reservoir mounting screw (3). Tighten screw to 28 Nm (250 inch lbs.) torque.
NOTE: SRT8 vehicles are not equipped with a master cylinder mounted pressure switch for the Electronic Stability Program. The switch is
located in the primary brake tube.
4. If equipped with Electronic Stability Program, install pressure switch (1) on bottom of master cylinder. Tighten switch to 28 Nm (250 inch lbs.)
torque.
5. Thoroughly bleed master cylinder before installing it on vehicle.
6. Install master cylinder on power brake booster. Upon installation, vacuum seal (2) on rear of master cylinder must be replaced.
INSTALLATION
1. Thoroughly bleed master cylinder before installing it on vehicle.
