Magnum SRT-8 V8-6.1L VIN 3 (2006)
Parking Brake Cable: Service and Repair
Rear
CABLE - PARKING BRAKE REAR
REMOVAL
NOTE: Before proceeding, Refer to Service Precautions.
1. Raise and support vehicle.
NOTE: Due to short travel and low spring tension, it is not necessary to lock-out parking brake lever to service parking brake components.
2. Disconnect rear parking brake cable near front cable as follows:
-
If removing left rear cable, disconnect cable (1) at equalizer (2) above rear axle differential (not shown) and rear crossmember (6).
-
If removing right rear cable, disconnect cable (4) at connector (3) above rear axle differential (not shown) and rear crossmember (6).
3. Remove parking brake shoes on side of cable service.
4. Remove shoe actuator lever (1) from end of cable (2) and support.
