Magnum SRT-8 V8-6.1L VIN 3 (2006)
6. If installing new lever, remove pin locking out automatic tensioning spring.
7. Connect parking brake release cable (4) at handle (5) in steering column opening cover (1).
8. Connect wiring connector (3) at decklid release switch.
9. Position steering column opening cover (1) and install fasteners (6) securing it in place.
10. Raise and support vehicle.
NOTE: Due to short travel and low spring tension, it is not necessary to lock-out parking brake lever to service parking brake components.
11. Connect front parking brake cable (5) at connector (3) to right rear parking brake cable (4).
12. Lower vehicle until rear wheels are just above floor level.
13. Apply parking brake lever. Release lever to test release cable and handle. Reapply lever. While doing this, check to make sure the red indicator
lamp in the cluster turns on and off properly.
14. Check to make sure rear wheels will not rotate with lever applied.
15. Release parking brake lever, then check to make sure rear wheels rotate without excessive drag.
16. Apply parking brake lever.
17. Lower vehicle.
