Rampage L4-135 2.2L (1983)
Fig. 37 Removing joint from shaft. Outer C/V joints
3. Support shaft in a soft jawed vise. Support the outer joint, and tap with a mallet to dislodge joint from internal circlip installed in a groove at the
outer end of the shaft. Do not remove slinger from housing.
Fig. 38 Circlip removal. Outer C/V joints
4. Remove circlip from shaft groove and discard.
5. Unless the shaft requires replacement, do not remove the heavy lock ring from shaft.
6. If constant velocity joint was operating satisfactorily and grease does not appear contaminated, proceed to "Assembly" procedure, step 7.
7. If the constant velocity joint is noisy or badly worn, replace entire unit. The repair kit will include boot, clamps, circlip and lubricant. Clean and
inspect the joint outlined in the following steps.
8. Clean surplus grease and mark relative position of inner cross, cage and housing with a dab of paint.
9. Hold joint vertically in a soft jawed vise.
Fig. 39 Ball removal. Outer C/V joints