Removal and Installation | -
Remove the engine undershield. - Rotate the locking tangs counterclockwise.
| 4. Remove the components in the order indicated in the following illustration(s) and table(s). 2 - Starter motor wiring harness support bracket 5. To install, reverse the removal procedure. Removal Details Item 1 : Starter motor electrical connectors | -
Disconnect the ignition switch and battery to starter motor solenoid cables. | Item 3 : Starter motor | -
Discard the starter motor gasket. | Installation Details Item 1 : Starter motor electrical connectors | -
Connect the ignition switch and battery to starter motor solenoid cables. | Item 3 : Starter motor | -
Install a new starter motor gasket into the transaxle housing prior to installing the starter motor. | |