| Removal and Installation Removal | | -
Remove the radiator grille. | | | -
NOTE:Make sure that the headlamp switch and the ignition switch are in the OFF postion. Remove the headlamp assembly. | | | -
Disconnect the headlamp assembly electrical connectors. | Installation Vehicles built up to 23.05.1999 NOTE:Processing, if condensation on the inside of the plastic headlamp lens should not disappear after a short period of time, when the headlamp is switched on. NOTE:Do not apply the quick drying adhesive to the vent hose because this may block the opening of the hose. NOTE:The angled end of the vent hoses must point downwards. | | -
Pull off the vent hoses and discard them. | | | -
Coat the mountings of the vent hoses on the headlamp housing with quick adhesive. | | | -
Push the vent hoses into the mountings on the headlamp assembly. | | | -
Repeat steps 1 to 3 for the other headlamp assembly. | All vehicles | | -
NOTE:Position the headlamp assembly with the guide pin. To install, reverse the removal procedure. | | 
