E 150 V8-4.6L SOHC VIN W (2004)
4. Tighten the engine front cover fasteners in sequence in three stages.
Stage 1: Tighten fasteners 1 through 7 to 25 Nm (18 ft. lbs.).
Stage 2: Tighten fasteners 6 and 7 to 48 Nm (35 ft. lbs.).
Stage 3: Tighten fasteners 8 through 15 to 48 Nm (35 ft. lbs.).
All engines
5. Position the belt idler pulley and install the bolt.
6. Connect the CMP electrical connection.
7. Install a new crankshaft front seal.
8. Loosely install the bolts, then tighten the bolts in the two stages following the sequence shown.
^
Stage 1: Tighten to 20 Nm (15 ft. lbs.).
^
Stage 2: Tighten an additional 60 degrees.