E 150 V8-4.6L SOHC VIN W (2004)
Ignition Switch Lock Cylinder: Service and Repair
Ignition Lock Cylinder - Non Functional
IGNITION LOCK CYLINDER - NON FUNCTIONAL
REMOVAL
NOTE: When a new lock cylinder is installed, the door lock cylinder and ignition lock cylinder should be installed as a set. This eliminates carrying and
extra key which will fit only one lock. If a new key is used, the new key code number is stamped on a metal tag attached to the key.
1. Remove the steering wheel.
2. Remove the cap from the ignition switch lock cylinder.
3. Remove the ignition switch lock cylinder.
-
Use a 1/8-inch diameter drill bit to drill out the lock cylinder retaining pin.
-
Use a 3/8-inch diameter drill to drill down the middle of the ignition lock key slot until the ignition switch lock cylinder breaks loose.
-
Remove and discard the ignition switch lock cylinder and the drill shavings from the steering column.
4. Remove the bearing retainer.
