E 450 V10-6.8L (2008)
11. NOTE: RH shown, LH similar.
Remove the RH and LH transmission crossmember-to-frame nuts and bolts and remove the transmission crossmember.
^
To install, tighten to 81 Nm (60 lb-ft).
12. Remove the 4 exhaust Y-pipe-to-exhaust manifold nuts and discard. Remove the exhaust Y-pipe from the vehicle.
^
To install, tighten the new upper exhaust Y-pipe-to-exhaust manifold nuts to 40 Nm (30 lb-ft) then tighten the new lower exhaust
Y-pipe-to-exhaust manifold nuts to 40 Nm (30 lb-ft).
13. To install, reverse the removal procedure.
^
If a new Torca(R) clamp needs to be installed, install the new Torca(R) in the same orientation as the original.
