Edge AWD V6-3.5L (2009)
1. NOTE: If installing a new LH or RH rear shade track, use the cable supplied with the replacement unit.
Feed the shade cables through the front of the shade track assemblies.
2. NOTE: LH shown, RH similar.
Install the LH and RH rear shade track stop screws.
3. NOTE: LH shown, RH similar.
Push the shade motor block tubes into the rear of the shade track assemblies and install the LH and RH rear shade track-to-drive tube bracket
screws.
-
Tighten to 5 Nm (44 lb-in).
4. NOTE: Protect the vehicle interior from cable grease.
NOTE: Make sure the front drive tubes are seated fully into the front guide tracks.
Holding the shade tracks and the motor block and tube assembly as one unit, insert the front shade cables into the mechanisms. Move the
mechanisms fully into the front guide tracks.
5. NOTE: LH shown, RH similar.
Install the center rear shade track-to-housing screws but do not tighten at this time.
6. NOTE: LH shown, RH similar.
Install the LH and RH 12 front guide track-to-housing screws.
-
Align the track to the marks previously made. Tighten to 5 Nm (44 lb-in).
