Edge AWD V6-3.5L (2009)
From the inside of the vehicle, begin cutting at the center and work towards the front corners.
2. NOTICE: Use caution when cutting to prevent damage to the side trim seals.
Continue working along the side and towards the rear corners.
3. Continue around the inside rear urethane adhesive path.
4. NOTICE: Use caution when cutting along the side to prevent damage to the side trim seals.
From the inside of the vehicle, work along the side of the glass.
5. From the inside of the vehicle, work from the center towards the rear corners.
5. Remove the fixed glass panel assembly.
Installation
NOTE: For additional material guidelines, refer to the manufacturer's installation information.
1. Dry fit the rear fixed glass to the existing urethane adhesive bead on the roof opening panel module surface.
-
Align the glass panel in the opening for a uniform fit.
-
Use a non-permanent pencil to make alignment marks on the glass and the roof opening panel module surface to aid in the installation
alignment of the glass panel.
-
Remove the glass panel and place on a stable work surface with the interior side facing upward.
2. NOTE: Avoid scratching the painted surfaces. Repair all minor scratches or exposed metal following manufacturer's instructions. Use the same
brand pinch weld primer, glass primer and urethane adhesive.
Using an appropriate tool, trim the urethane adhesive leaving a 1-2 mm (0.04-0.08 in) base of original equipment urethane adhesive along the roof
opening module surface.
3. NOTE: Make sure the water channel is free from any foreign material.
Using a soft brush or vacuum, remove any dirt or foreign material from the roof opening panel module.
4. If installing the original glass panel, remove the excess urethane adhesive.
