Disassembly and Assembly of Subassemblies Special Tool(s) | Slide Hammer 205-102 (15-053) | | Remover/Installer Selector Shaft Oil Seal 308-040 (16-019) | Materials Name Specification Universal sealer ESEE-M4G1008-A Disassembly | -
Remove the selector shaft oil seal. | | -
CAUTION:The shift gate is set in production. If it is detached, a service shift gate must be installed in its place. Remove the auxiliary selector shaft. - Remove the bolts from the relay lever mounting.
- Remove the auxiliary selector shaft together with the relay levers.
| | -
NOTE:Ease of movement and correct resetting to "neutral" position. Check the relay levers and the detent mechanism. - Relay lever (shift).
- Relay lever (select).
- Return spring (shift mechanism in neutral)
| | -
Remove the selector shaft and the reverse gear shift lever. - Remove the bolt, pull out the selector shaft and remove the selector block.
- Pull out the selector shaft and remove the selector block.
- Remove and discard the snap ring and remove the reverse gear shift lever with spring.
| Assembly | -
NOTE:Replace the reverse gear shift lever snap ring. Install the selector shaft and the reverse gear shift lever. - Insert the selector block.
- Insert the selector shaft, coat bolt with universal sealer and install.
- Install the reverse gear shift lever with spring and install a new snap ring.
| | -
CAUTION:The shift gate is set in production. If it is detached, a service shift gate must be installed in its place. Install the auxiliary selector shaft. - Install the auxiliary selector shaft together with the relay levers.
- Install the bolts.
| | -
NOTE:Replace the selector shaft oil seal. Install the selector shaft oil seal. | |