ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

ABOUT US
206-09B Anti-Lock Control - Traction Control > < Front Wheel Speed Sensor

Fiesta 2002.25 (11.2001-)

Anti-Lock Control - Rear Wheel Speed Sensor Ring Fiesta 2002.25 (11/2001-)
Removal and Installation

Special Tool(s)

Installer, ABS Sensor Ring

206-083
General Equipment
Soft faced hammer

Removal

Vehicles with rear drum brakes
  1. Remove the brake drum.
    For additional information, refer to: Brake Drum (206-02 Drum Brake, Removal and Installation).
Vehicles with rear disc brakes
  1. Remove the dust cap.
  1. Remove the brake disc.
    For additional information, refer to: Brake Disc (206-04 Rear Disc Brake, Removal and Installation).

  1. Remove the wheel hub.
    • Remove and discard the wheel hub retaining nut.
All vehicles
  1. Remove and discard the wheel speed sensor ring (brake disc shown).

Installation

All vehicles
  1. CAUTION:
    CAUTION:Make sure the wheel speed sensor ring is not knocked, damaged and kept free from metal fragments.
    CAUTION:
    CAUTION:Protect the face of the wheel speed sensor ring with a non-ferrous flat block to prevent damage.
    CAUTION:
    CAUTION:Make sure the wheel hub or brake drum is adequately supported and do not allow it to rest on the wheel studs.
    CAUTION:
    CAUTION:Make sure the wheel speed sensor ring is pressed on slowly and squarely until fully seated.
    CAUTION:
    CAUTION:Do not exceed a maximum load of 10 kN.
    Using the special tool, install a new wheel speed sensor ring (brake disc shown).
Vehicles with rear disc brakes
  1. CAUTION:
    CAUTION:Avoid any impact on the wheel speed sensor ring.
    CAUTION:
    CAUTION:Make sure the wheel speed sensor ring is clean.
    CAUTION:
    CAUTION:Avoid any contact between the wheel speed sensor ring and a magnetic surface.
    CAUTION:
    CAUTION:Rotate the hub assembly 10 times counter-clockwise when tightening the wheel hub retaining nut to prevent damage to the wheel bearing.
    NOTE:
    NOTE:Install a new wheel hub retaining nut.
    Install the wheel hub.
  1. Install the brake disc.
    For additional information, refer to: Brake Disc (206-04 Rear Disc Brake, Removal and Installation).

  1. NOTE:
    NOTE:If the dust cap is damaged a new dust cap must be installed.
    Using a soft faced hammer and a wooden block, install the dust cap.
Vehicles with rear drum brakes
  1. CAUTION:
    CAUTION:Avoid any impact on the wheel speed sensor ring.
    CAUTION:
    CAUTION:Make sure the wheel speed sensor ring is clean.
    CAUTION:
    CAUTION:Avoid any contact between the wheel speed sensor ring and a magnetic surface.
    Install the brake drum.
    For additional information, refer to: Brake Drum (206-02 Drum Brake, Removal and Installation).

206-09B Anti-Lock Control - Traction Control > < Front Wheel Speed Sensor