Ford Workshop Service and Repair Manuals
HOME
FEATURES
MENU
INDEX
ABOUT US
Halfshaft Seal LH >
< Turbine Shaft Speed (TSS) Sensor
Focus 1999 (08.1998-12.2004)
Mechanical Repairs
3 Powertrain
307 Automatic Transmission-Transaxle / 307-01 Automatic Transmission-Transaxle - Vehicles With: 4F27E
Description and Operation
Diagnosis and Testing
General Procedures
In-vehicle Repair
Output Shaft Speed (OSS) Sensor
Automatic Transmission/Transaxle - Vehicles With: 4F27E - Output Shaft Speed (OSS) Sensor
Focus 1999 (08/1998-12/2004)
In-vehicle Repair
Materials
Name
Specification
Automatic transmission fluid
WSS-M2C202-B
Thread sealer
SD-M4G9107-A
Removal
Raise and support the vehicle. For additional information, refer to Section
100-02 Jacking and Lifting
.
Place a drain pan beneath the output shaft speed (OSS) sensor.
Remove the OSS sensor.
Disconnect the electrical connector.
Remove the bolt.
Inspect the OSS bore.
Inspect the O-ring seal for nicks or cuts; install a new as necessary.
Installation
NOTE:
Apply a light coat of petroleum jelly to the O-ring before installation.
NOTE:
Apply thread sealer to the bolt.
Install the OSS sensor.
Connect the electrical connector.
Lower vehicle.
Check the transmission fluid level, add
automatic transmission fluid
as necessary.
Start the engine and move the transaxle range selector lever through all gear positions.
Mechanical Repairs
3 Powertrain
307 Automatic Transmission-Transaxle / 307-01 Automatic Transmission-Transaxle - Vehicles With: 4F27E
Description and Operation
Diagnosis and Testing
General Procedures
In-vehicle Repair
Output Shaft Speed (OSS) Sensor
Halfshaft Seal LH >
< Turbine Shaft Speed (TSS) Sensor