Removal and Installation | -
Remove the accessory drive belt. For additional information, refer to: Accessory Drive Belt - Vehicles Built Up To: 02/2008 1.8L Duratec-HE (MI4)/2.0L Duratec-HE (MI4) (303-05A Accessory Drive, Removal and Installation). | | -
Detach the fuel charging wiring harness and position to one side. - Detach the fuel charging wiring harness from the retaining clip.
- Disconnect the fuel charging wiring harness electrical connector.
| | -
Detach the engine wiring harness retaining clips from the engine. | | -
Detach the engine wiring harness electrical connector from the retaining clip and position the engine wiring harness one side. | 5. Remove the components in the order indicated in the following illustration(s) and table(s). 1 - Accessory drive belt tensioner 6. To install, reverse the removal procedure. |