ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

ABOUT US
414-05 Voltage Converter-Inverter > < Generator - 2.0L Duratorq-TDCi (DW) Diesel, Vehicles Without: Water-in-Fuel Sensor

Focus 2004.75 (07.2004-)

Generator and Regulator - Generator—2.5L Duratec-ST (VI5) Focus 2004.75 (07/2004-)
Removal and Installation

Removal

NOTE:
NOTE:Removal steps in this procedure may contain installation details.
  1. Remove the accessory drive belt.
    Refer to: Accessory Drive Belt (303-05B Accessory Drive - 2.5L Duratec-RS (VI5)/2.5L Duratec-ST (VI5), Removal and Installation).
  1. Lower the vehicle.
  1. Disconnect the battery ground cable.
    Refer to: Battery Disconnect and Connect (414-01 Battery, Mounting and Cables, General Procedures).
  1. Remove the intake manifold.
    Refer to: Intake Manifold (303-01D Engine - 2.5L Duratec-ST (VI5), Removal and Installation).

  1. CAUTION:
    CAUTION:Make sure that the inside of the pipe ends are clean and free of oil residue.

  1. Torque: 10 Nm

  1.  
    1. Torque: 15 Nm
    1. Torque: 25 Nm

Installation

  1. NOTE:
    NOTE:Install all the bolts finger tight before final tightening.
    To install, reverse the removal procedure.
  1. Initialize the door window motors.
    Refer to: Door Window Motor Initialization (501-11 Glass, Frames and Mechanisms, General Procedures).

414-05 Voltage Converter-Inverter > < Generator - 2.0L Duratorq-TDCi (DW) Diesel, Vehicles Without: Water-in-Fuel Sensor